GE AKTA avant User Manual

7.8 Replacement procedures
About this section
This section gives instructions for the replacement procedures to be performed by the
user of ÄKTA avant.
WARNING
Disconnect power. Always disconnect power from the instrument
before replacing any component on the instrument, unless stated
otherwise in the user documentation.
In this section
This section contains the following subsections:
See pageSection
3367.8.1 Replace tubing and connectors
3387.8.2 Replace the Mixer
3407.8.3 Replace the O-ring inside the Mixer
3427.8.4 Replace the UV monitor U9-M flow cell
3457.8.5 Replace UV monitor U9-L flow cell
3477.8.6 Replace Flow restrictor
3487.8.7 Replace the inlet filters
3497.8.8 Replace pump head check valves
3527.8.9 Replace pump rinsing system tubing
3547.8.10 Replace a valve module
3577.8.11 Replace pump pistons, piston seals, O-rings and rinse mem-
branes
ÄKTA avant User Manual 29035184 AE 335
7 Maintenance
7.8 Replacement procedures

GE AKTA avant Specifications

General

Brand	GE
Model	AKTA avant
Category	Laboratory Equipment
Language	English