GE GTW330ASK_WW User Manual

– 9 –
Throughout this manual, features and appearance may vary by model.
Control Features
(Continued next page)
A
Power
Press to “wake up” the display. If the display is active, press to put the washer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
B
Start/Pause
Press Start to begin the cycle. NOTE: The lid must be closed for the washer to start the cycle. If the lid is open, “Lid” will
scroll across the display. If the lid is closed, the lid will lock, the Lid Lock light will illuminate, and “SEnSing” will scroll
across the display.
Pressing Pause will unlock the lid (if locked at that time), pause the cycle and the Start indicator light will blink.
To continue the cycle, press Start again. If the machine is paused more than 24 hours, the cycle will be cancelled. If
water remains in the machine, select the Drain & Spin cycle to drain basket and spin water out of the washer basket.
C
Display and Status Lights
Display: The display shows the approximate time remaining until the end of the cycle. NOTE7KHF\FOHWLPHLVDȺHFWHG
E\KRZORQJLWWDNHVWKHZDVKHUWR¿OO7KLVGHSHQGVRQWKHZDWHUSUHVVXUHLQWKHKRPH7KHVL]HRIWKHORDGEHLQJ
ZDVKHGDOVRVLJQL¿FDQWO\LPSDFWVF\FOHWLPHZLWKODUJHUORDGVWDNLQJORQJHU
In addition, this display will, “scroll” the washer status:
• bALAnCINg Start of rebalancing cycle to redistribute clothes. Stops after rebalancing is complete.
• dELAY When Delay Wash is initiated. Replaced with estimated time when cycle starts.
• End End of current cycle.
• FILL )RUWKH¿UVWVHFRQGVRID¿OOWKHHVWLPDWHGHQGRIF\FOHWLPHLVGLVSOD\HG)RUWKHUHVWRIWKH¿OO
WLPH´),//µLVVFUROOHGXQWLOWKH¿OOFRPSOHWHV
• H2O SUPPLY &DQQRWVHQVHZDWHUOHYHOYDOYHVSRVVLEO\WXUQHGRȺ
• LId Cycle stopped because lid is open. Close the lid.
• SEnSIng 6HQVLQJORDGVL]HDQGW\SHEHIRUHDQGGXULQJ¿OOQRUPDO
• PAUSE Cycle paused because the Start/Pause button was pressed and the washer was set to Pause.
Press the Start button again to restart the cycle.
Cycle status lights: Shows whether the washer is in the Delay, Fill, Soak, Wash, Rinse or Spin portion of the cycle.
If an out-of-balance condition is detected by the washer, the Spin light will blink during the remaining portion of the
cycle and will stay illuminated for a short time after cycle completion. When this occurs, the washer is taking actions to
correct the out-of-balance condition and complete the cycle normally. In some cases, the washer may not be able to
balance the load and spin up to full speed. If the load is more wet than normal at the end of the cycle, redistribute the
load evenly in the wash basket and run a Drain & Spin cycle.
Feature status lights indicate (see sections F and G for more details):
Pause Will display when washer is paused between cycles.
Controls The washer is locked - will blink once if any button is pressed or the cycle knob is turned.
Lid Lock The lid is locked. See the Control Lock description.
Spin Stop Indicates wash basket is coasting to a stop following spin. Lid will not unlock until basket has fully
come to a stop.
GTW680 Models

GE GTW330ASK_WW Specifications

General

Brand	GE
Model	GTW330ASK_WW
Category	Washer
Language	English