GE JVM1430 User Manual

Installation Instructions
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enougll for tile power cord to fit through,
and a cutout large enougll for tile exhaust adaptor.
" Read tile instructions on tile TOP CABINET
TEMPI ATE.
• Tape it underneath the top cabinet.
• Drill tile holes, following tile instructions on tile
TOP CABINET TEMPI,ATE.
CAUTION: Wear satety goggles when drilling holes
in the cabinet bottom.
CHECK FOR PROPER
DAMPER OPERATION
BlowerPlate
Exhaust Adaptor
(absent on models shipped
for recirculation exhaust)
_,, Backof
Microwave
• Place tile microwave in its upright position, with tile
top of tile unit thcing up.
• This microwave oven may be shipped assembled tor
top exhaust (adaptor installed) or tor recirculation
exhaust (adaptor absent).
• Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
" You xdll need to make adjustments to assure proper
alignment _dth your house exhaust duct after tile
microwave is installed.
MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTAIJATION AND PERSONAI,
SAFETY, WE RE( OMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of tile cord.
NOTE: We recommend using fillet blocks if the
cabinet fiont hangs below the cabinet bottom shell
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting
tile ulicI'OWaVe oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1-3. Do [] IJft inicrowave, tilt it
not pincll cord or lift oven
by pulling (ord. "-- fot_vard, and hook
• slots at back bottom
edge onto Ibm lower
tabs of mounting
plate.
13
_ Rotate flont of oven
up against cabinet
bottom.
[] Insert a self aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.

GE JVM1430 Specifications

General

Brand	GE
Model	JVM1430
Category	Microwave Oven
Language	English