Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR
RECJRCULATJON (continued}
[] Place tile bh)wer unit back into tile opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
[]Secure blower unit to ini(iowave Xddl tile s(iew
reinoved in Step 4.
[] Replace bh)wer plate with tile screw reinoved in
Step 1.
T
1
_ Backof
o...L'_II "I Microwave
MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTAI,I,ATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is inetal, use the nylon groininet
around the power cord hole to prevent cutting of the
cord.
NOTE: We recoininend using filler blocks if tile
cabinet tiont hangs below tile cabinet bottoin shelE
IMPORTANT: If filler blocks are not used,
case damage may occur from over tightening
screws.
21
NOTE: When inounting
tile ulicrowave ()veil,
thread power cord
through hole in bottoin of
top cabinet. Keep it tight
throughout Steps 1-3. Do [] IJft inicrowave, tilt it
not pinch cord or lift oven
by pulling cord. forward, and hook
slots at back bottoin
edge onto fimr lower
tabs of inounting
plate.
/
_ Rotate flont of oven
up against cabinet
bottoln.
[] Insert a sell:aligning screw through top center
cabinet hole. Teinporarily secure tile oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
fight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
CabinetFront
CabinetBottomShelf
FillerBlock
Equivalentto Depth
f CabinetRecess
Self-AligningScrew
MicrowaveOvenTop
_Attach tile inicrowave oven to tile top cabinet.
To Next Page
Loading...
Need help?
General
