Installation Instructions
OUTSIDE BACK EXHAUST (Horizontal Duct)
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Attach Mounting Plate to Wall
B3. Prepare Top Cabinet
B4. A(ljust Blower
B5. Mount the Microwave Oven
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
[] Place the mounting plate against tile rear wall and
align it with the holes drilled earlier.
[] Using a pencil, put (lots through holes/notches F,
G, H and I (see above illustration). Remove the
mounting plate and draw lines extending through
the points. This will give the location and size of the
box cutout tin the rear wall duct.
[] Use a saw (saber or keyhole) to cut out the opening.
[] Place tile microwave in its upright position with tile
top of the unit lacing up.
This microwave oven is shipped assembled ti)r top
exhaust. You will need the exhaust adaptor fin.
installation in the rear wall opening. To remove the
exhaust adaptor tiom tile microwave oven:
[] Remove tape securing damper.
_ Lift offthe
[] Remove and, blower plate
save screw _, Damper and attached
that holds *,_, adaptor flom
blower plate ,,
tO IIlicI'owave.
[] Slide exhaust adaptor to one side and remove it.
5
To Next Page
Loading...
Need help?
General
