GE JVM1430 User Manual

Installation Instructions
CHECK MICROWAVE ASSEMBLY
Exhaust Adaptor (absent
on models shipped for
recirculatirm exhaust
Backof
Microwave ;
• Place tile microwave in its upright position, with tile
top of tile unit lacing up.
• The microwave oven may be shipped assembled fin.
top exhaust (adaptor installed) or for recirculation
exhaust (adaptor absent),
" If tile microwave was shipped for recirculation
exhaust, skip to C5. If shipped fin top exhaust,
proceed with (4.
ADAPTING MICROWAVE
BLOWER FOR RECIRCULATION
[] Relnove _._ D_nper [] Lifloffthe
and save , blower plate
screw that ...... and attached
holds adaptor flom
blower the microwave.
,,
plate to
nlicrowave.
ackof
Microwave
[] Slide exhaust adaptor to one side and relnove it.
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save theln for possible fhture use.
Remove and save tile screw that holds tile bh)wer
II1OLOI" 1o tile illiciowave.
_ BlowerPlate
_.___ Backof
<_ _ Microwave
o--....,,.._;,cO=
[] Carefhlly pull out tile bh)wer unit. Tile wires
xdll extend far enough to alh)w you to adjust tile
bh)wer unit.
[] Roll tile bh)wer unit 90 ° so that fan blade
openings
are facing toward the flrmt of the mi(rowave.
BEFORE: Fan Blade
Openings Facing
R011
I
AFTER: Fan Blade
Forward
NOTE: Make sure wires remain routed in tile grooves
of tile motor flame.
20

GE JVM1430 Specifications

General

Brand	GE
Model	JVM1430
Category	Microwave Oven
Language	English