GE JVM3162RJSS User Manual

31-7000173 Rev. 0 21
Installation Instructions
USE TOP CABINET TEMPLATE
FOR
PREPARATION OF TOP
CABINET
C3.
•
Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
A
C
D
B
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Roll the blower unit 90° so that fan blade
openings are facing out the back of the
oven.
4
BEFORE: Fan Blade
Openings Facing Up
2
1
Remove and save the two screws that hold the
blower plate in place. Slide blower plate from
under its retaining flange. Remove the cover
plate installed on the back. Remove and save
screws that hold blower unit to the oven
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
C4.
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
Blower
Plate
Before Rolling
After Rolling
Back of
Oven
Back of
Oven
Retaining
Flange
Back of
Oven
3
Rotate blower unit counterclockwise 180°.
Before Rotation After Rotation
Back of
Oven
Back of
Oven

GE JVM3162RJSS Specifications

General

Style	over the range
Color	stainless steel
Total Capacity	1.6 cu. ft.
Convection	no
Power Levels	10
Fan Speeds	2
Venting Type	convertible
Sensor Cooking	no
Quick Start	1-6 minutes
Timer	yes
Interior Light	bright/night/off; incandescent; yes
Microwave Power	1, 000 watts
Electrical Requirements	120 v / 60 hz
Voltage	120 volts
Current	14

Weight and Dimensions

Depth	15 7/8 inch
Height	16 7/16 inch
Width	29 7/8 inch
Net Weight	56 lbs.