EasyManuals Logo
Home>GE>Microwave Oven>JVM3162RJSS

GE JVM3162RJSS User Manual

GE JVM3162RJSS
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
38 31-7000173 Rev. 0
AFTER: Fan Blade
Openings Facing
Forward
3
2
4
ADAPTING BLOWER
FOR RECIRCULATION
C3.
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save them for possible future use.
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
Roll the blower unit 90° so that fan blade openings
are facing toward the front of the oven.
Roll
Slide the blower plate from under its retaining
flange and lift it off.
Remove and save screws that hold blower plate
and blower unit to the oven. Remove the cover
plate installed on the back
Installation Instructions
BEFORE: Fan Blade
Openings Facing Up
1
Blower
Plate
Retaining
Flange
Blower Plate
Back of
Oven
Blower Plate Screws
Blower Motor Screw
Cover Plate

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE JVM3162RJSS and is the answer not in the manual?

GE JVM3162RJSS Specifications

General IconGeneral
Styleover the range
Colorstainless steel
Total Capacity1.6 cu. ft.
Convectionno
Power Levels10
Fan Speeds2
Venting Typeconvertible
Sensor Cookingno
Quick Start1-6 minutes
Timeryes
Interior Lightbright/night/off; incandescent; yes
Microwave Power1, 000 watts
Electrical Requirements120 v / 60 hz
Voltage120 volts
Current14
Weight and Dimensions IconWeight and Dimensions
Depth15 7/8 inch
Height16 7/16 inch
Width29 7/8 inch
Net Weight56 lbs.

Related product manuals