© 2010 by General Electric Company. All rights reserved. 2049809-001 Rev B 17
Chapter3 :Mini Telemetry Components
Component Description
5. Channel Number:
The channel number is the customer-
designated frequency of the receiver.
For each telemetry system, the channel
number of the receiver must be identical
to the channel number of the transmitter.
Also, if you have more than one telemetry
system, or other RF devices, each system
must have a unique channel number.
Receiver Rear Panel
The following table describes the components of the Receiver rear panel:
Component Description
1. Equipotential Lug:
Binding post terminal, which is directly connected
to chassis, for use as an equipotentiality connector.
2. Transmitter Placeholder:
Placeholder provided for the transmitter.
3. Antenna Connector:
Twist-on connector for attaching the receiver
antenna.
4. AC Line Connector and Fuseholder Module:
This module houses the AC-line input connector
and the main fuses for the receiver:
• 100-120 VAC: requires two, 0.25 A slow-
blow fuses.
• 220-240 VAC: requires two, 0.25 A slow-
blow fuses.
To Next Page
Loading...
Need help?
General
