GE NetworX NX-4 User Manual

NX-4 Control
Page 11
PROGRAMMING EXAMPLE – FIGURE 1 (Numerical Data)
Zone 1 LED = 1
Zone 4 LED = 8
}
Data = 9
Zone 2 LED = 2
Zone 7 LED = 64
}
Data = 66
To change data in a
segment, enter the data
followed by []
Enters the previous
programming “location”.
Pressing [#] will exit a
location without
changing the data in
the current segment.
Advances to the next
programming “location”.
Returns to the “location” just
programmed.
PROGRAMMING EXAMPLE –
FIGURE 2
(Feature Selection Data)
Location 23  Segment 1
1 = Quick Arm
2 = Re-Exit
3 = Auto Bypass
4 = Silent Keypad Panic
5 = Audible Keypad Panic
6 = Keypad Auxiliary 1
7 = Keypad Auxiliary 2
8 = Multi-Keypad Tamper
Press the key on the numeric keypad that corresponds to the feature you wish to enable/disable. When an LED is
“on, a feature is enabled; when “off” the feature is disabled. For example: With the 1, 5, & 7 LEDs “on”, Quick Arm,
Audible Keypad Panic and Keypad Auxiliary 2 are enabled.

GE NetworX NX-4 Specifications

Power

operating power	16.5 VAC 25, 40, or 50 VA Transformer
auxiliary power with 25 VA transformer	12 VDC Regulated 500 mA
auxiliary power with 40 or 50 VA transformer	12 VDC Regulated 1 AMP

Operating Environment

loop resistance	300 Ohms Maximum
loop response	500mS
operating temperature	32 to 120 degrees F

Weight and Dimensions

led keypad dimensions	6.4" Wide, 4.0" High, 1.1" Deep
nx-148e lcd keypad dimensions	6.4" Wide, 5.3" High, 1.0" Deep
metal enclosure dimension	9.25" Wide, 8.25" High, 3.50" Deep