GE Security
g
ADDING AND CHANGING USER CODES
Your system must be Disarmed to add/change user codes.
Step 1 Press [r]-[5]
Step 2 Enter a “Master Arm/Disarm Code”.
NOTE: For partitioned systems, someone changing the code of another person
must have access to all or more partitions than the user being changed.
Step 3 Enter the 2 digit (applies to NX4/6/8) or 3 digit (applies to NX8E) “user number” (always
enter 2 digit such as [0] - [3] for user 3, or [1] - [0] - [0] for user 100).
The LCD keypad will display the current code for this user. Stars (r) represent blanks.
Note: To delete a user code, press four times (for a 4-digit code), or six times (for a 6-digit
code) the [Cancel] key.
Step 4 Enter the new four (4) or six (6) digit “user code”. If you are changing the current code, you
may use the up and down scroll keys to select the digit to change and enter the correct
number. If it rejects the code because of duplication or such, the sounder will beep 3 times.
Step 5 If another “user code” needs to be programmed, return to Step 2.
Step 6 Press the [#] key while the ready light is flashing to exit the User Code Programming Mode.
NX-148E User manual Page 13 04/10/04
To Next Page
Loading...
Need help?
General