GE Security
g
Change languages
This function allows you to switch between the two languages programmed in your keypad.
NOTE: You must exit any other function mode before attempting to change languages.
Step 1 Press [r] [4] [9]. The LCD display switches to the other language.
Step 2 To switch back to the other language, only step 1 has to be repeated.
Detector reset function
This function is used to reset Smoke Detectors and Zone Troubles. Your system must be Disarmed to use
the Reset function.
Step 1 Press [r]-[7]. Resets have now been performed. The FIRE light will go off if the smoke
detectors have been reset.
Step 2 If the keypad begins beeping, the reset did not execute properly. Enter your code to silence
the keypad. Wait a few minutes and repeat step 2 to attempt another reset. If the keypad still
beeps after repeated attempts, please contact your installer.
Reading the event log
The control panel has an event log that can be retrieved using a master code. This log contains a listing of
the events along with date, time, and partition where the event occurred. An overview of possible events can
be found in Appendix A of this manual.
Step 1 To view the log, press [r] [9][0]. The LCD screen will prompt you for a code.
Step 2 Enter your [master code]. The LCD screen will now show the most recent event.
Step 3 To view the events from most recent to the oldest, press the [] down scroll key.
Step 4 To view the events from the oldest to the newest, press the [] up scroll key.
The display contains the following information.
Event User or Zone ID
Date Indicates partition
(Month/Day) and [*] indicates an
Open 75
9/25 17:57 P3*
Time shown in event not reported
24 hour format
This screen shows an opening of Partition 3 on September 25th at 5:27 p.m. by user 75. The
[r] shows that this event is not programmed to be reported to the central monitoring station.
NX-148E User manual Page 18 04/10/04
To Next Page
Loading...
Need help?
General