GE Security
g
PARTITIONED SYSTEMS OPERATION
This system is
“ multi-partitioned
“ not partitioned
If your system is multi-partitioned and the keypad resides in one partition, your keypad will provide the status
of the zones in your partitioning by using the screen messages described earlier in this manual. The Master
Mode of operation (if programmed by your installer) allows you to access any partitioning (providing your code
is authorized) within the system and perform functions in other partitions.
NOTE: [r][1] will temporarily access the Master Mode. The keypad will revert back to its assigned
partition 60 seconds after a keypress, or 10 seconds without a keypress.
Read the following paragraphs to help you understand the different screen messages that will be displayed
from your keypad.
Lights in partitioning master mode
• ARMED: will illuminate if ALL partitions are armed.
• READY: will illuminate if ALL partitions are "Ready".
The ready light will flash if all areas are Ready or Force armable.
• FIRE: will illuminate if ANY one area has a Fire condition.
The fire light will flash if ANY area has a Fire Trouble condition.
• POWER: will illuminate if the primary power is connected to the control panel.
It will flash if the system has a low standby battery condition.It will be off if the
primary power is absent.
• STAY: will illuminate if ANY area has the stay light on.
• CHIME: will illuminate if ANY partition is in the "Chime" mode.
• EXIT: will illuminate if ANY area is timing an exit delay. It will flash if ANY area is in the last
10 seconds of an exit delay.
• BYPASS: will illuminate if ANY area has a zone bypassed.
• CANCEL: will flash during an abort delay time. If a code is entered followed by the[CANCEL]
key while this light is flashing, all abortable reports will stop the communication to the
central station.
Remark: the dialer abort delay time must be programmed by your installer.
If a code is entered followed by the [CANCEL] key during or after an alarm report, the
cancel light will illuminate and remain constant until the central station has received
the cancel report.
Remark: the cancel feature must be enabled by your installer.
• SOUNDER: will sound if ANY area has the sounder on. This includes Entry delay, Exit
delay, Chime, and Alarm.
NX-148E User manual Page 20 04/10/04
To Next Page
Loading...
Need help?
General