GE Security
g
Arming your system in the “STAY mode”
STAY is utilized when the user is inside the premise and wants protection around the perimeter. The steps to
arm in the STAY Mode are as follows:
Step 1 Close all protected doors and windows.
• Ready light must be on or flashing when all protected zones
and sensors are secure. NOTE: If any zones are bypassed, a sensor in that zone can
be violated without affecting the ready light.
• The security system will not arm if the ready light is not on or flashing.
• If the power light is off, you have no AC power. Restore
power if possible. If not, contact your installing company for
service. If the power light is flashing, you have a battery
failure. Contact your installing company for service.
Step 2 Enter your 4 or 6 digit user code. (Optional, if programmed.)
• If “Auto Bypass” is enabled, all interior zones will be bypassed if you do not leave through
a designated entry/exit door. If Auto Bypass is enabled, omit Step 3.
• When “Auto Instant” is enabled, if you do not leave through a designated entry/exit door,
the display will read “Instant”, indicating that the entry/exit doors no longer have an entry
delay. If “Auto Instant” is enabled, omit Step 4.
Step 3 Press the [STAY] key.
• The bypass light will illuminate indicating that designated interior zone(s) are bypassed.
(All interior devices will bypass automatically, giving the user freedom of movement within
the interior area.)
• The stay light will also illuminate. NOTE: Normally, all entry/exit doors are delayed.
System Ready
Type Code to Arm
System Armed
Instant
Step 4 To toggle from a “delayed entry mode to “Instant” mode, press
the [STAY] key again. The LCD display will read “Instant”
meaning the entry/exit doors do NOT have an entry delay.
Using the Quick Arm (optional)
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user to arm the security system
in the AWAY mode by pressing the [EXIT] key, or arm in the STAY mode by pressing the [STAY] key. This
feature is used for ARMING ONLY, and will not disarm the security system. This is ideal for a maid or baby
sitter code, etc.
NX-148E User manual Page 9 04/10/04
To Next Page
Loading...
Need help?
General