GE Security
g
Exit Light The exit light is “on” during the exit delay. Please note that the light will flash during the last
10 seconds of the exit delay as a warning that the time is running out. (The user may want
to disarm the system if the exit light is flashing in order to prevent an alarm. The user may
then re-arm the system and exit before the delay expires.)
Fire Light A steady fire light means a fire zone has been faulted. A rapidly flashing fire light means that
a fire zone is in a trouble condition.
Power Light The power light is on if the primary power is on. The power light will flash if the system has a
low battery condition.
Ready Light The ready light is “on” when the system is ready to arm and “flashes” if ready to force arm.
The ready light is “off” when the system is not ready to arm because of a zone(s) being
faulted.
Stay Light The stay light is illuminated when
all interior zones are bypassed.
Instant Message The LCD display will read “Instant“ when the entry/exit door(s) have no delay. (See “Arming
System in Stay Mode”) The doors can be changed from instant to delay (toggled) by
pressing the [STAY] key when the system is armed.
EMERGENCY ACTIVATION KEYS
NOTES: You must hold these keys for 2 seconds to activate these functions. Your system may not be
programmed for these activation keys. You should press these keys only in an emergency situation that
requires response by emergency personnel. If your system is programmed for these functions, the following
reports can be sent.
Fire Key – This key can activate the fire alarm when pressed for two seconds. If your system is connected to
a monitoring center, an emergency report could be sent to that center.
Auxiliary Emergency Key – This key can activate the auxiliary alarm when pressed for two seconds. If your
system is connected to a monitoring center, an emergency report could be sent to that center.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm when pressed for two seconds. If
your system is connected to a monitoring center, an emergency report could be transmitted to that center.
NOTE: Some Panic/Hold-Up alarms are programmed to be silent at the protected site while reporting an
alarm to the monitoring center. Check with your installing company to determine how your security system will
respond to the Panic/Hold-Up activation.
NX-148E User manual Page 7 04/10/04
To Next Page
Loading...
Need help?
General