PROTEUS XR/a
GE MEDICAL SYSTEMS Operator Manual
REV 11 DIRECTION 2259724-100
6-3
6-2 Introduction
This section provides a general description for the Proteus XR/a table.
ILLUSTRATION 6-1
PROTEUS XR/A TABLE
1 Table Top
2 Table Base
3 Foot Pedals (on both side)
4 Cassette Tray
5 Bucky Film Cabinet Motion
6 Bucky Film Cabinet
7 Table Elevating Motion
8 Maximum Table Top Height (800mm)
9 Table top motion
10 Emergency stop
11 Table inhibition button
The Proteus XR/a Table is a radiographic positioner composed of:
- Table top.
The table top is made of foam. Its dimensions are 2200mm in length
and 880mm in width. Its filtration is less than 1.1 mm of aluminum at
100 KV.
The table top can be moved longitudinally and transversely for easy
patient positioning. Even when it is fully extended horizontally it can
support a prostrate patient weighing up to 220 kg (484 lbs.), in
accordance with Standard UL2601.
- Elevating Base.
The elevating base raises the table top to a maximum height of 800
mm (31.5”) and lowers it to a minimum height of 500 mm (19.6”).
The table power supply and electronics are located in the table base.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
