JB Academy, JB Nova and SUB Aqua Pro 31394 V7
Detailed operating manual Page 5
www.grantinstruments.com
4.2 Safety symbols
The symbols below are marked on the equipment and in this manual to indicate:
Caution: Surfaces and water can be hot during and after use
Read this manual before using the bath
Important safety warning
Recommended operation
Failure to follow may affect the performance of the equipment
4.3 Safety warnings
Read the whole of the instructions. Safety may be impaired if they are not
followed.
Surfaces and water can be hot during and after use. Before emptying a bath,
allow the water temperature to fall to a safe level. For 12, 18, 26, dual & 34
litre baths, empty the bath before moving it.
This bath is only intended for use with water or metallic heat transfer beads.
Use of other fluids or heat transfer media may invalidate the warranty and
present a risk of fire or explosion.
The tray must be removed when using heat transfer beads.
Place on a stable flat surface to reduce the risk of accidental spillage.
No user serviceable parts. Risk of electric shock after disassembly or
operation with covers removed.
Not for use in environments with a risk of flammable or explosive gases.
To be operated within the limits listed in this guide
Only use the mains cord provided or one with an identical rating. Ensure that
the mains plug and the switch are easily accessible.
A clearance of >10cm around the bath is required to ensure adequate air
flow.
If a potentially hazardous liquid is spilt onto the equipment, disconnect it from
the power supply and have it checked by a competent person. It is the user’s
responsibility to carry out appropriate decontamination if hazardous material
is spilt on the equipment.
Clean the outside of the equipment with a damp cloth, using water and
domestic cleaning products only. The use of other chemical cleaning agents
may damage the equipment. Always follow the manufacturer’s instructions
and any applicable legislation about the use of potentially hazardous