Wired Controller XK46
22
3.4 FAN SETTING
Under On status, pressing FAN button can set fan speed circularly as:
Note:
① In Dry mode, fan speed is low and can’t be adjusted.
② When the wired controller is connected with a Fresh Air Indoor Unit, fan speed of
indoor unit will be high fan speed only. Fan speed of indoor unit can’t be adjusted
via “FAN” button.
③ If indoor unit’s fan speed is set auto, indoor unit will change fan speed
automatically according to room temperature in order to make the room
temperature more stable and comfortable.
3.5 TIMER SETTING
The wired controller is equipped with two kinds of timer: general timer and clock
timer. General timer is factory defaulted setting. Please refer to Section 3.2.3 for the
timer setting way.
3.5.1 General Timer
Unit On/Off after a desired hour can be set through general timer.
Set Timer: when timer is not set, press TIMER button to enter timer setting and
“HOUR” icon is blinking. Press “ ” or “ ” button to adjust timer time. Press TIMER
button to save the setting and then exit setting.
(2) Turbo function setting
Start turbo function: In unit on status, press “FUNCTION” button to switch to
Turbo function with Turbo function icon “ ”blinking, and then press
“ENTER/CANCLE” button to start Turbo function. When Turbo function is
activated, Turbo function icon “ ”will be bright.
Cancel Turbo function: When Turbo function is activated, press “FUNCTION”
button to switch to Turbo function with Turbo function icon“ ” blinking, and
then press “ENTER/CANCEL” button to cancel Turbo function ; Press “FAN”
button to cancel turbo function and start auto speed.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
Need help?
General
