Wired Controller XK46
21
View the air outlet
temperature of
Fresh Air Indoor
Unit*
Enter viewing, short-press “MODE” button in
“C20” status to enter the interface of viewing air
outlet temperature of Fresh Air Indoor Unit.
Press “ ” or “ ” button to select the indoor
unit.
Display method:
Temperature zone: displays current indoor unit
project number
Timer zone: displays air outlet temperature of
Fresh Air Indoor Unit
Note: only applicable to Fresh Air Indoor Unit.
Note:
① Under parameter viewing status, FAN, TIMER, SLEEP and SWING buttons
are invalid. Press “ON/OFF” button to go back to the home page, while not to
turn on/off the unit.
② Under parameter viewing status, the signal from remote controller is invalid.
3.2.3 Parameter Setting
Unit parameters can be set in unit On or Off status.
(1) Long press FUNCTION button for 5s and the temperature zone displays “C00”;
long press FUNCTION button for another 5s to enter the interface of setting
wired controller parameters. “P00” is displayed in temperature zone;
(2) Press “ ” or “ ” button to select parameter code. Press MODE button to
enter parameter setting. At that time, parameter value is blinking. Press “ ” or
“ ” button to adjust the parameter value and press ENTER/CANCEL button to
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
Need help?
General
