English (GB)
3
1.1.3 Obligations of the user
• Observe the recognised health and safety regulations as well
as the local accident prevention regulations.
• Wear protective equipment in accordance with local health
and safety regulations when working on the product and
handling chemicals.
• Read and understand this document.
1.2 Symbols used in this document
The text accompanying the three hazard symbols DANGER,
WARNING and CAUTION is structured in the following way:
1.3 Symbols on the product
2. Safety instructions
2.1 Work procedures
Before starting to work, make sure to observe the following
points:
• The area must be clean and kept free from objects the user
can trip over.
• There must be sufficient light to operate the product safely.
• If information, symbols and warnings are illegible or unclear,
replace them immediately with new ones.
2.2 Personal protective equipment
There are no requirements for personal protective equipment
during normal operation of the product.
If the analysed liquid contains chemicals or if chemicals are used
for cleaning or flushing, wear personal protective equipment
according to the safety data sheet for the chemical.
3. Storing and handling the product
3.1 Transporting the product
• Wear safety shoes during transport and installation.
• Wear a helmet if lifting the product higher than hip level.
• Drain the product completely.
• Check and observe the centre of gravity before lifting.
• Use appropriate lifting and transporting equipment.
• Make sure that the product is not exposed to any point load
during the transport.
• Avoid strong impacts.
• If using a forklift, make sure the forks are long enough to
support the weight of the product in its entire depth.
• Observe the permissible ambient conditions. See section
12.3 Ambient conditions.
3.2 Storing the product
• Observe the permissible ambient conditions. See section
12.3 Ambient conditions.
• The storage location must be protected from rain, humidity,
condensation, direct sunlight and dust.
• For storage for a long period of time, prepare the product
according to section 10. Taking the product out of operation.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious personal injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate personal injury.
SIGNAL WORD
Description of hazard
Consequence of ignoring the warning.
- Action to avoid the hazard.
A blue or grey circle with a white graphical symbol
indicates that an action must be taken.
A red or grey circle with a diagonal bar, possibly with
a black graphical symbol, indicates that an action
must not be taken or must be stopped.
If these instructions are not observed, it may result in
malfunction or damage to the equipment.
Tips and advice that make the work easier.
If you touch this part of the product, it may lead to
electric shock with consequent risk of serious
personal injury or death.
WARNING
Electric shock
Death or serious personal injury
- Keep liquids away from the power supply and
electrical components.
- Before starting work on the product, make sure
that the power supply has been switched off and
that it cannot be accidentally switched on.
If you need to transport the product after it was
commissioned, contact a Grundfos service specialist.
To Next Page
Loading...
Need help?
General