10
Loading the salt into the softener
WARNING:
Only use salt specifically designed for dishwashers use!
Every other type of salt not specifically designed for dishwasher use, especially table salt, will
damage the water softener. In case of damages caused by the use of unsuitable salt the
manufacturer does not give any warranty nor is liable for any damages caused.
Only fill with salt before running a cycle.
This will prevent any grains of salt or salty water, which may have been spilled, remaining on
the bottom of the machine for any period of time, which may causecorrosion.
The salt container is located the lower basket. Please follow the steps below for adding
dishwasher salt:
Remove the lower basket and unscrew the reservoir cap.
2. Place the end of the funnel (supplied) into the hole and pour in about 1kg of dishwasher
salt.
3. Fill the salt container to its maximum limitwith water, It is normal for a small amount of
water to come out of the salt container.
4. After filling the container, screw back the cap tightly.
5. The salt warning light will stop being after the salt container has been filled with salt.
6. Immediately after filling the salt into the salt container, a washing program should be
started (We suggest to use a short program). Otherwise the filter system, pump or other
important parts of the machine may be damaged by salty water. This is out of warranty.
NOTE:
The salt container must only be refilled when the salt warning light ( ) in the control
panel comes on. Depending on how well the salt dissolves, the salt warning light may
still be on even though the salt container is filled.
If salt has spilled, run a soak or quick program to remove it.
To Next Page
Loading...
Need help?
General
