3-90-00674R20_08/12
As you can see, the control board is easily accessible
from the rear with the body pulled out of the frame, even
if it is only pulled out several inches.
• Always inspect the wiring harness of the 11 pin socket
(large white at plug where all of the power wires
terminate.)
• Always inspect the wiring harness where the wires
transfer from the control to the rear inside of the body.
• Make sure there are no worn or frayed areas.
Install the log bracket with the two thumb screws
provided.
Center the log in the rebox opening with the bottom
front edge over the thumb screws. The log branch tips
only rest on the bracket arms for easy installation and
removal.
•
•
Fig.42
Thumb
Screws
Fig. 40
Inspect the wiring harness transition area: This is the area
that comes closest to the mounting frame as the unit is slid
in and out of the frame.
Hopper lid foam
gaskets
Cast Top
Fig. 41
To Next Page
Loading...
Need help?
General
