3-90-00674R20_08/12
Make sure the unit is plugged into a properly grounded,
120 VAC, 60 Hz electrical source. The power light
should be the only light lit.
1. Turn Mode Selector to "OFF".
2. Fill hopper with pellets.
1
3. Clean burn pot with scraper, if necessary.
5
4.If starting after an empty hopper, turn Feed Adjuster
to "TEST" (for one 60 second cycle).
2
This will ow
pellets into the auger tube and also allow you to check
the motors for operation.
5. Turn Feed Adjuster to #4.
4
6. Flip the Igniter Switch up into the "AUTO" position.
7. Turn the Temperature Dial to the desired room
temperature.
8. Turn Mode Selector to Room Temperature or Stove
Temperature.
9. Fill hopper with pellets and remove ashes as
required.
6
Keep the hopper lid and rebox doors closed while in
operation. Maintain door seals in good condition. Failure
to do so will affect operation of the appliance and may
permit escape of smoke or gases into the living space.
1. Fines are small pieces of broken pellets (sawdust). Fines
do not ow easily and often build up on the hopper funnel
bottom angles. These nes can be pushed into the feeder
opening and then ll the hopper with pellets. As the system
works, they will be burned.
2. The "TEST" cycle will operate the feed motor for exactly
one minute. Turning to "TEST" again and again may load
too much fuel into the burn pot causing excessive smoke
on start-up.
3. The rebox low pressure switch will not allow the auger
motor or the igniter element to operate if the view door is
open.
4. Adjust Feed Rate. If this is your rst re or you are trying
different pellets, set the feed adjuster to #4, Fig. 1. This is a
conservative number and will probably need to be increased.
After you know a feed rate setting that works well, use that
setting. Remember, if your feed rate is too high you may
waste fuel.
5. This is usually a weekly maintenance procedure. Cleaning
the burn pot with the scraper with a small amount of new fuel
in the bottom is not a problem. First, scrape the ashes off the
front of the burn pot into the ash pan. Then scrape the holed
surface downward into the burn pot. When the stove feeds,
these scrapings will be pushed out by the feeder.
6. The ash pan can hold the ashes from approximately 1 ton
of premium fuel. This means the ashes will only need to be
emptied a few times a year.
7. Setting the feed adjuster # for maximum burn: With the
unit burning in "AUTO", turn to "Stove Mode" and put the fan
on "H". Set the Temperature Dial to #7. Allow the unit to burn
for about 30 minutes and check ash on front of burn pot. Fig.
2. If the ash line is larger than 1", turn the feed adjuster from
#4 to #5. Allow another 30 minutes of burn time and check
again. If, at #6 setting, a 1" or less ash bed is not obtainable,
it is not a problem. The 1" ash bed is only at maximum burn
rate and during normal operation, the ash bed will be larger.
See Note 7.
Fig. 2
1"
Fig. 1
To Next Page
Loading...
Need help?
General
