Hayward Sense and Dispense User Manual

ORP Setting If ORP controls chlorination (page 10), adjust setpoint from 400mV to 900mV. If
ORP does not control chlorination, adjust from 0% to 100%.
On/Off Enable and disable ORP sensing and chlorine generation.
Schedule Enable and disable chlorine generation based on time. You can set a unique sched-
ule for the chlorinator that will override filter pump settings. See the OmniLogic
manual for details on how to create schedules.
SC Superchlorinate allows you to select a continuous run time for maximum chlorina-
tion.Selectaruntimebetween0-96hours.TheOmniLogicwilloverridepump
schedules and generate chlorine continuously for this amount of time.
Diag Displays electrical diagnostics for the Turbo Cell.
Controlling ORP with the OmniLogic
Follow these steps to adjust the desired ORP level:
1. IMPORTANT: Balance the pool water to the ideal levels shown in the OmniLogic manuals,
including pH, total alkalinity, cyanuric acid, hardness and salt level.
2. Adjust the chlorine to the ideal level as well; e.g. 1-3 ppm free chlorine. This chlorine level is
what we want to maintain.
3. Afterallowingthesystemtorunfor30-60minutes,observewhattheSenseandDispense
system reports as the pool water ORP level.
4. Set the ORP setpoint setting to this reported ORP level.
5. Monitor the free chlorine and ORP every day for 1 week. If adjustments to the ORP setpoint
areneeded,makeadjustmentsinincrementsof10or20mVunits—LARGEADJUSTMENTS
OF THE ORP SETPOINT SHOULD NOT BE NECESSARY IF YOU STARTED WITH A BALANCED
DIAG
POOL
chlorinator
SC
average
50%
ON
15
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Hayward Sense and Dispense Specifications

General

Brand	Hayward
Model	Sense and Dispense
Category	Measuring Instruments
Language	English