Pump Overcurrent
0 Times
Out of Water
0 Times
The number of times the unit has realized
a low load on the pump motor.
Out of Water Causes
1. Attempting to run the unit out of the water/pool.
2. Air trapped in the filter after placing the unit in the water.
3. Bench testing in manufacture or repair.
4. Machine climbing too high above the waterline.
5. Low voltage at power source.
6. Low voltage from use of an extension cord.
7. Worn or defective pump motor, drawing less than 1
amp at 24 volts.
Number of times the pump motor has realized
an over load condition. Unit will stop after 3-5
seconds in this condition.
Pump Over Current Causes
1. Debris around the pump impeller. Remove impeller and
inspect for hair or grass around pump shaft.
2. Defective pump motor. Motor should turn smoothly by
hand with only a slight resistance from the shaft seals.
Using The Scanner Tool
Page 33
To Next Page
Loading...
Need help?
General
