Page 40
¾Will not climb walls
Confusion on normal operation
Confusion on normal operation
¾Climbs Too High, Falls off Wall at Waterline, Blows Air
Bubbles Through the Exit Venturi
• Above average traction in a clean pool. Install the Restrictor Plate Kit RCX11206 in
the venturi.
• Inspect bottom lid filter plate gasket and replace if torn or missing.
• Set handle position at an angle, machine should never operate with the handle in the
center or straight position.
• Check water chemical balance.
Troubleshooting
• The startup of each 4 hour cycle may require up to 30 minutes as the machine
measures the pool configuration before climbing the walls completely to the water
line.
• During the 4 hour cycle the machine will randomly re-measure the pool configuration
or release itself from the wall. The machine will not climb the walls during this 15-30
minute cycle.
To Next Page
Loading...
Need help?
General
