Thermal Image Scope User Manual
8
Figure 2-6 Change Eyepiece
2.5 Power On/Off
Power On
When the battery is sufficiently charged, hold for about 2 seconds to power on the device.
Power Off
When the device is turned on, hold for about 2 seconds to power off the device.
Auto Power Off
Set the auto power off time for your device, and then the device will automatically shut down as
the set time.
Steps
1. Hold to go to the menu.
2. Press or to select , and press to select the auto power off time as
required.
3. Hold to save and exit.
Note
● See the battery icon for the battery status. means the battery is fully charged, and
means that the battery is low.
● When the low power note shows, charge the battery.
● The auto power off countdown will start again when the device exits standby mode, or the
device is restarted.
To Next Page
Loading...
Need help?
General
