Thermal Image Scope User Manual
18
Chapter 6 Measure the Distance
The device can detect the distance between the target and the observation position.
Before You Start
When measuring the distance, keep the hand and the position steady. Otherwise, the accuracy
may be affected.
Steps
1. Hold to show the menu.
2. Select and press to go to the setting interface.
1) Press or to select the target from Deer, Wolf, Bear, and Custom.
2) Set the target height.
Note
The available height ranges from 0.1 m to 9.9 m.
3) Press to confirm.
3. Align the center of top mark with the edge of target top. Press .
Figure 6-1 Set the Edge of Target Top
The cursor blinks on the top edge of the target.
4. Align the center of bottom mark with the edge of target bottom. Press .
To Next Page
Loading...
Need help?
General
