User Manual of IR Network Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
3. Set the tampering area. Refer to Step 1 Set the Motion Detection Area in Section
6.6.1 Configuring Motion Detection.
4. Click to edit the arming schedule for tampering. The arming
schedule configuration is the same as the setting of the arming schedule for motion
detection. Refer to Step 2 Set the Arming Schedule for Motion Detection in Section
6.6.1 Configuring Motion Detection.
5. Check the checkbox to select the linkage method taken for the tampering. Notify
surveillance center, send email and trigger alarm output are selectable. Please refer
to Step 3 Set the Alarm Actions for Motion Detection in Section 6.6.1 Configuring
Motion Detection.
6. Click to save the settings.
6.6.4 Configuring External Alarm Input
Steps:
1. Enter the Alarm Input Settings interface:
Configuration > Advanced Configuration> Events > Alarm Input:
2. Choose the alarm input No. and the Alarm Type. The alarm type can be NO
(Normally Open) and NC (Normally Closed).
3. Edit the name in to set a
name for the alarm input (optional).
To Next Page
Loading...
Need help?
General
