HIKVISION DS-2SE7C43C432MW-AEB User Manual

9.2.4 Nofy Surveillance Center
Check Nofy Surveillance Center, the alarm informaon is uploaded to the surveillance center
when an alarm event is detected.
9.2.5 Trigger Recording
Check Trigger Recording, and the device records the video about the detected alarm event.
For device with more than one camera channels, you can set one or more channels to take
recordings if needed.
For recording
sengs, refer to Video Recording and Picture Capture
9.2.6 Flashing Light
Aer enabling Flashing Light and seng the Flashing Light Alarm Output, the light ashes when
an alarm event is detected.
Set Flashing Alarm Light Output
When events occur, the ashing light on the device can be triggered as an alarm.
Steps
1.
Go to Conguraon → Event → Basic Event → Flashing Alarm Light Output .
2.
Set Flashing
Duraon, Flashing Frequency and Brightness.
Flashing Duraon
The me that the ashing lasts when one alarm happens.
Flashing Frequency
The rate at which the light ashes. High frequency, medium frequency, low frequency, and
normally on are selectable.
Brightness
The brightness of the light.
3.
Set the arming schedule. See
Set Arming Schedule for details.
4.
Click Save.
Note
Only certain device models support the funcon.
TandemVu PTZ Camera User Manual
71

HIKVISION DS-2SE7C43C432MW-AEB Specifications

General

Brand	HIKVISION
Model	DS-2SE7C43C432MW-AEB
Category	Security Camera
Language	English