HIKVISION DS-2TD2 Series Quick Start Guide

DS-2TD2xxx-xx/xx Thermal and Optical Bi-Spectrum Network Bullet Camera Quick Start Guide
QSG DS-2TD2xxx-xx/xx 071720NA 18
• Detect Target: The target should be at least 1.5 pixels on the image.
• Recognize Target: The target should be at least 6 pixels on the image.
• Identify Target: The target should be at least 12 pixels on the image.
This table is for reference only, and the actual detection range may vary due to camera
settings, mounting condition, monitor, etc.
Install Camera
2.3.1 Install Type I Camera
1. Fix the bullet camera with mounting bracket with expansion screws or bolts, as shown below.
Bolts
Figure 19, Install the Bracket onto the Wall
2. Fix the bullet camera to the mounting bracket with the supplied screws, as shown below.
Bolts
Figure 20, Fix the Camera to the Bracket
3. Bolt the camera body to the bracket.

HIKVISION DS-2TD2 Series Specifications

General

Brand	HIKVISION
Model	DS-2TD2 Series
Category	Security Camera
Language	English