DS-2TD2xxx-xx/xx Thermal and Optical Bi-Spectrum Network Bullet Camera Quick Start Guide
QSG DS-2TD2xxx-xx/xx 071720NA 29
Figure 41, SADP Interface
The SADP software supports activating the camera in batch. Refer to the SADP software user
manual for details.
Create a password, input the password in the password field, and confirm the password.
STRONG PASSWORD RECOMMENDED − We highly recommend that you create a strong password
of your own choosing (using a minimum of eight characters, including at least three of the
following categories: upper case letters, lower case letters, numbers, and special
characters) in order to increase the security of your product. We also recommend that you
reset your password regularly. Especially in high security systems, resetting the password
monthly or weekly can better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
4. Click OK.
5. Check whether the activation is completed on the pop-up window. If activation failed, make sure that
the password meets the requirement and try again.
Modify the IP Address
Purpose
To view and configure the camera via a LAN (Local Area Network), you need to connect the network
camera in the same subnet with your PC. Then, install the SADP software or client software to search and
change the network camera’s IP address. We will take modifying the IP address via SADP software as an
example to introduce IP address modification.
Run the SADP software.
Select an active device.
Refer to Chapter 3.2 to activate the camera if the camera is inactive.
To Next Page
Loading...
Need help?
General
