User Manual of Digital Video Recorder
115
change it according to different requirements.
Server Port and HTTP Port: Enter the Server Port and HTTP Port in the text fields. The
default Server Port is 8000 and the HTTP Port is 80, and you can change them according to
different requirements.
Note: The Server Port should be set to the range of 2000-65535 and it is used for
remote client software access. The HTTP port is used for remote IE access.
Enable Telnet: Telnet function provides an easy way to get access to the DVR. You can see the
advanced information about the device by inputting command; as well the configuration can also
be realized through telnet connection.
Figure 9. 20 Configure More Settings
4. Click the Apply button to save and exit the interface.
9.2.6 Configuring Email
Purpose:
The system can be configured to send an Email notification to all designated users if an alarm event is
detected, a motion detection event is detected, etc.
Before configuring the Email settings, the device must be connected to a local area network (LAN) that
maintains an SMTP mail server. The network must also be connected to either an intranet or the Internet
depending on the location of the e-mail accounts to which you want to send notification.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Set the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway and the Preferred DNS Server in the Network
Settings menu.
To Next Page
Loading...
Need help?
General