User Manual of Digital Video Recorder
21
2.3 Using the Wizard for Basic Configuration
The Setup Wizard can walk you through some important settings of the device. By default, the Setup Wizard
starts once the device has loaded.
By default, the Setup Wizard starts once the device has loaded.
Figure 2. 6 Start Wizard Interface
Operating the Setup Wizard:
1. The Start Wizard can walk you through some important settings of the device. If you don’t want to use
the Start Wizard at that moment, click Exit. You can also choose to use the Start Wizard next time by
leaving the “Start wizard when device starts?” checkbox checked.
2. Click Next to enter the date and time settings window.
Figure 2. 7 Date and Time Settings
3. Click Next button which takes you back to the Network Setup Wizard window, as shown in Figure 2.8.
Set the network parameters, including the NIC type, IPv4 address, IPv4 subnet mask, default gateway,
etc. You can enable the DHCP to automatically obtain an IP address and other network settings from
that server.
To Next Page
Loading...
Need help?
General