or “Motion | Alarm”. Please refer to chapter 5.12 for recording setup.
Step 7: Motion alarm schedule: When the motion alarm is happened in
schedule, DVR will response such as “On Screen Warning”, “Audible Warning” (Not
available), “Upload to Center” and “Trigger Alarm Output”. You can setup 4 time
periods for one day and 7 days for one week.
Note: Time periods in one day can not be repeated.
Step 8: Motion alarm handle method setup: You can select one or more handle
methods such as “On Screen Warning”, “Audible Warning” (Not available), “Upload
to Center” and “Trigger Alarm Output”.
Note: If “On Screen Warning” is enabled, when there is motion alarm
happened and DVR is in preview mode, DVR will switch to the related camera.
If you trigger more than one camera, DVR will pop-up them one by one every 10
seconds. When the motion alarm is disappeared, DVR will restore preview mode.
Step 9: Save motion alarm setup: Press “Confirm” button to return “Image
Setup” menu. In the “Image Setup” menu, press “Confirm” button to save the current
camera parameters.
Step 10: Save all cameras: You can repeat from step2 to step8 to setup motion
detection parameters for other cameras. Also you can copy the parameters of one
camera to any other cameras.
Note: Motion alarm area can not be copied.
If you want to disable motion alarm area and motion alarm policy, you just need
to select the motion alarm sensitivity as “Off”.
5.11 Preview
After the device started, the preview screen will be seen; then you can press
“PREV” key to switch between one screen and four screens; also you can switch to
the other single screen by pressing “EDIT”; or in “SHIFT” mode you can press
numeric keys to switch to the screen no. you want.
In “Preview” menu, you can setup preview mode, screen switch time, enable or
disable audio preview and preview layout.
Step 1: Enter “Preview” menu: In the main menu, move “Active Frame” to
“Display” icon and press [ENTER], then go to “Preview Setup” and press [ENTER],
you can enter “preview” menu. Shown as Fig.5.20 below
To Next Page
Loading...
Need help?
General