User Manual of Embedded Net DVR
Page 50 Total 113
5.4 Video Output Standard and VGA Setup
Video output standard
There is one VOUT BNC connector at the rear panel of DVR. It is used to connect with analog
monitor and can support PAL or NTSC video output. You can modify video output standard to
match video input.
In “Display” menu:
There is a list box named “Video Output Standard”, you can useÇÈkey to select PAL or
NTSC video output.
VGA setup
There is one VGA interface at the real panel of DVR. You can use it to connect with VGA
display. You can define VGA resolution, refresh frequency in “Display” menu.
There are following options: 1024*768/60Hz, 800*600/60Hz and 800*600/75Hz. You can use
ÇÈkey to select.
Press “Confirm” button to save or “Cancel” to abort.
To Next Page
Loading...
Need help?
General