User Manual of Embedded Net DVR
Page 42 Total 113
player software in attached CD.
Exit playback interface
Please refer to chapter 4.6.
4.8 Voice Talk
VOIPis not available.
You can use client software to start talking with DVR.
4.9 Auxiliary Video Output
Note: Only DS-8016HSI has this function.
PressMONkey, you can switch any channel live video input to one of the four auxiliary
video output. The steps are following:
Step 1: PressMONto enter into video matrix control mode.
Step 2: Select one auxiliary video output port. Press numeric key (1-4) to select, you can
see the video output channel number on the front LCD screen.
Step 3: Select video input channel. Press two numberic keys to select video input channel
(01-16), the corresponding channel video will be displayed on that auxiliary video output. You can
press other two numeric keys to output the corresponding channel video.
Step 4: Define other auxiliary video output. Repeat above steps.
Step 5: Exit matrix control mode. PressESCkey.
For example: PressMONto enter into video matrix control mode, press1to select the first
auxiliary output port, press01, then the video of 1
st
channel will be displayed on that 1
st
auxiliary output; If you press15numeric key, the video of 15
th
channel will be displayed on the
1
st
auxiliary output. PressESCto exit matrix control mode.
4.10 Shut Down DVR
Note: Do not switch off the power directly in case of damaging HDD. The correct step is
using “Power Off” in the “Utilities” menu, orPOWERkey on the front panel or on IR
controller.
To Next Page
Loading...
Need help?
General