User Manual of Embedded Net DVR
Page 77 Total 113
Sequence setup: Each sequence is made up of several curise points. Each cruise point includes
one preset number, dwell time and dwell speed. Please make sure the PTZ you are using can
support sequence function before you start to setup. You can save 16 sequnece.
Cruise setup: Cruise is remembering the track of PTZ movement. Please make sure the PTZ
you are using can support cruise function.
Preset setup
In “PTZ” menu, move “Active Frame” to “Setup” button on the right side of “Preset” item,
pressENTER, you can enter into “Preset” setup menu:
Add preset number: You can input preset number (among 1-128) in the edit box. Then press
“Adjust” button to enter into PTZ control interface. In PTZ control interface, you can use direction
keys to adjust PTZ position, and useIRIS+IRIS-FOCUS+FOCUS-ZOOM+ZOOM-
keys to adjust iris, focus and zoom. After you finish adjusting, pressENTER, then press “Save”
button to save the preset number. You can repeat this step to setup other preset numbers.
After you setup all preset numbers, press “Return” button to return “PTZ” menu. In “PTZ”
menu, press “Confirm” button to save all parameters.
Delete preset number: In “Preset” setup menu, input one preset number, press “Delete” button,
you can delete this preset number.
After deleting, press “Return” button to “PTZ” menu. In “PTZ” menu, press “Confirm” button
to save all modification.
Please make sure the PTZ you are using can support preset function.
Sequence setup
In “PTZ” menu, press “Setup” button on the right side of “Sequence No” item, you can enter
To Next Page
Loading...
Need help?
General