Access Control Terminal·Quick Start Guide
40
3. Modify system parameters, including switching the mode, entering the login
password, and enabling voice prompts.
Mode: The device mode can be switched between Controller and Card Reader.
After switching the mode, the system can automatically reboot and enter into the
interface of the new mode.
If the access control terminal works as a card reader, you should configure the serial
port settings. See details in 6.2.2.
Login Password: To reset the login password of the device, you should enter a new
password, and confirm it.
Voice Prompts: After enabling voice prompts, you can hear the voice prompts to
notify you the card status when you swipe the card. Otherwise, you will hear the
beeper in place of the voice prompts.
Beep three times: legal card.
Beep four times: illegal card.
Click the key to enter and exit the editing mode.
Click the Right/Left direction keys to choose contents.
Click the # key to switch the mode between “Yes” mode and “No” mode.
4. Move the cursor to the OK button, and click the # key.
6.3.2 Managing Data
Purpose:
On the data management interface, you can delete the storage data of the device.
Steps:
1. Move the cursor to Data (data management) by using direction keys in the system
settings Interface.
2. Click the # key to enter the data management interface.
Figure 6-22 Data Management Interface
To Next Page
Loading...
Need help?
General
