HIKVISION DS-K1T341CMF User Manual

Steps
1.
Click Access Control → Advanced Funcon → Authencaon .
2.
Select an access control device (support the funcon of person authencaon) on the le panel
to enter the person
Authencaon Mode page.
3.
Click Add to enter the Add window.
4.
Select the person(s) need to be congured on the le panel.
The selected person(s) will be added to the right panel.
5.
Select the authencaon mode on the drop-down list of Authencaon Mode.
6.
Click OK.
Figure 9-9 Set Authencaon Modes for Persons
7.
Oponal: Select person(s) on the Person Authencaon mode page, and then click Apply to
apply the person authencaon mode to the device.
Note
Person authencaon has higher priority than other authencaon mode. When the access
control device has been congured person authencaon mode, the person should authencate
on this device via person authencaon mode.
9.7.6 Congure Card Reader Authencaon Mode and Schedule
You can set the passing rules for the card reader of the access control device according to your
actual needs.
Steps
1.
Click Access Control → Advanced
Funcon → Authencaon to enter the authencaon mode
conguraon page.
2.
Select a card reader on the
le to congure.
3.
Set card reader authencaon mode.
1) Click Conguraon.
DS-K1T341C Series Face Recognion Terminal User Manual
168

HIKVISION DS-K1T341CMF Specifications

General

Type	Face recognition terminal
Product color	Black, Silver
Cards capacity	3000 cards
Event capacity	150000
Access code reader	-
Authentication type	Access chip/card, Face recognition
Face recognition distance	0 - 2 m
Face recognition duration	0.2 s
Access chip/card reader type	Contact
International Protection (IP) code	IP65
Operating system installed	Linux
Screen shape	Flat
Display diagonal	4.3 \
Maximum resolution	272 x 480 pixels
Touchscreen technology	Capacitive
Total megapixels	2 MP
Ethernet LAN data rates	10, 100 Mbit/s
Power consumption (typical)	10 W
Operating temperature (T-T)	-30 - 60 °C