The client soware gives an audible warning when the event is triggered. You can select
alarm sound for the audible warning.
Note
For details about seng the alarm sound, refer to Set Alarm Sound in the user manual of
the client soware.
Send Email
Send an email
nocaon about the event to one or more receivers.
For details about
seng email parameters, refer to Set Email Parameters in the user
manual of the client
soware.
2) Click OK.
5.
Enable the event so that when the event is detected, event will be sent to the client and the
linkage
acons will be triggered.
6.
Oponal: Click Copy to to copy the event sengs to other access control device, alarm input,
door, or card reader.
9.8.2
Congure Device Acons for Access Event
You can set the access control device's linkage acons for the access control device's triggered
event. When the event is triggered, it can trigger the alarm output, host buzzer, and other acons
on the same device.
Steps
Note
It should be supported by the device.
1.
Click Access Control → Linkage Conguraon .
2.
Select the access control device from the list on the
le.
3.
Click Add buon to add a new linkage.
4.
Select the event source as Event Linkage.
5.
select the event type and detailed event to set the linkage.
6.
In the Linkage Target area, set the property target to enable this
acon.
Buzzer on Controller
The audible warning of access control device will be triggered.
Capture
The real-me capture will be triggered.
Access Point
The door status of open, close, remain open, and remain close will be triggered.
DS-K1T341C Series Face Recognion Terminal User Manual
179
To Next Page
Loading...
Need help?
General
