HIKVISION DS-K1T343EFX User Manual

Note
If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
4.
Tap the back icon at the upper le corner and you should reboot the device if you change the
parameters.
7.2.4 Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
1.
Tap Comm.
(Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2.
On the Communicaon Sengs page, tap Wiegand to enter the Wiegand tab.
Figure 7-7 Wiegand Sengs
3.
Enable the Wiegand funcon.
4.
Select a transmission direcon.
●
Output: A face recognion terminal can connect an external access controller. And the two
devices will transmit the card No. via Wiegand 26 or Wiegand 34.
●
Input: A face
recognion terminal can connect a Wiegand card reader.
5.
Tap to save the network parameters.
DS-K1T343 Series Face Recognion Terminal User Manual
33

HIKVISION DS-K1T343EFX Specifications

General

Brand	HIKVISION
Model	DS-K1T343EFX
Category	Touch terminals
Language	English