HIKVISION DS-K27 Series User Manual

Click Auto Recognize, enter card No. to recognize the Wiegand mode. Enter the Card No., and
click Start to Recognize. Present the card on the related card reader. The system will show the
Wiegand mode. Click OK.
If select Custom, you should set custom Wiegand parameters. Click Custom Wiegand
Sengs, and set the name, parity type, total length and Wiegand rule. Click OK.
Wiegand Mapping Card Reader
Select the Wiegand card reader related door and card reader
direcon.
4.
Click Save to save the sengs.
Note
If you change the peripheral, and aer you save the device parameters, the device will reboot
automacally.
Door Magnec Contact Sengs
Set the opening and closing door status of the door magnec contact to match the actual wiring
method.
Before You Start
The access controller has connected to the door magnec contact.
Steps
1.
Click System and Maintenance → Maintenance → Device Access → Host Parameter to enter
the
sengs page.
2.
Select the door magnec contact status.
Barrier Open Status (Default)
The door
magnec contact is in open status in default. Access controller is connected to the
door magnet contact through NO.
Door Closed Status
The door magnec contact is in closed status in default. Access controller is connected to the
door magnet contact through NC.
9.7.12 Card
Sengs
Set Card Security
Click System and Maintenance → System Conguraon → Card Sengs → Card Type to enter the
sengs page.
Set the parameters and click Save.
Enable NFC Card
DS-K27XX Series Access Controller User Manual
64

HIKVISION DS-K27 Series Specifications

General

Brand	HIKVISION
Model	DS-K27 Series
Category	IP Access Controllers
Language	English