HIKVISION DS-KD8003-IME2 User Manual

Click Refresh to get the present informaon.
Arming/Disarming Informaon
Click User Management → Arming/Disarming Informaon to
view the informaon. Click Refresh to get the present
informaon.
7.3.4 Network Sengs
TCP/IP Sengs
TCP/IP sengs must be properly congured before you operate
the device over network. The device supports IPv4.
Steps
1. Click Network → Basic
Sengs → TCP/IP to enter the sengs
page.
Figure 7-6 TCP/IP Sengs
2. Congure the network parameters.
-
Enable DHCP and the device will get the parameters
automacally.
-
Disable DHCP and set the IPv4 Address, IPv4 Subnet Mask
and IPv4 Default Gateway manually.
3. Congure the corresponding DNS server parameters.
4. Click Save to enable the sengs.
Port Sengs
Steps
1. Click Network → Basic Sengs → Port to enter the sengs
page.
61

HIKVISION DS-KD8003-IME2 Specifications

General

Megapixel	2 MP
Maximum frame rate	30 fps
Supported video modes	720p, 1080p
Viewing angle, vertical	96 °
Maximum video resolution	1920 x 1080 pixels
Viewing angle, horizontal	180 °
Video codecs	H.264
Number of buttons	1 buttons
Streaming capability	Yes
Connectivity technology	Wired
Maximum number of cameras supported	-
Voice codecs	G.711u
Product color	Black, Grey
International Protection (IP) code	IP65
Operating relative humidity (H-H)	10 - 95 %
Door station operating temperature (T-T)	-40 - 60 °C
Indoor unit included	No
Outdoor unit power type	DC
Display diagonal	- \
Harmonized System (HS) code	85176920