Table 9-7 SSB codes returned by the pairsplit command
pairsplit
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B980 B901 The command was rejected because the specified
port is for NAS Platform (System LU).
Table 9-8 SSB codes returned by the pairsplit -S command
pairsplit -S
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B980 B901 The command was rejected because the specified
port is for NAS Platform (System LU).
SSB codes returned by the configuration setting command (raidcom)
Executing the configuration setting command (raidcom command) can return
an SSB code. An error can occur whether the command is executed
synchronously or asynchronously. For an asynchronous error, the error
information is displayed on the console by executing raidcom get
command_status command. When the error message shows "CMDRJE" or
"Get Command Status", check the contents of SSB1 and SSB2. You can verify
a content of an error by the raidcom get error_message command. When you
specify the SSB code with the raidcom get error_message command, make
sure not to specify a wrong SSB code.
The following tables provide information about each SSB code returned by
the configuration setting command (raidcom command). If you see an error
not described in the tables, contact Hitachi Data Systems customer support.
Table 9-9 SSB codes returned by the configuration setting command (common)
common
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE
Get Command
Status
Executing/
Async
2E10 8000 The operation cannot be performed because
Storage Navigator or Device Manager - Storage
Navigator is in progress, another application is in
progress on the SVP, or the configuration is being
changed. Wait a while, and then retry the
operation.
CMDRJE Executing 2E11 2205 The resource group to which the operation object
belongs is locked by the other user.
9-24
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
Need help?
General