2X
4X
8X
Zero Setting
1. Fusion Calibration: Aligning the red dot and the digital reticle.
1） The fusion calibration of the camera image and the actual object image has been performed at the factory.
2） During dusk and dawn periods, lighting is sufficient to obtain a sight picture through the objective lens with
the digital night vision image overlay to enhance visibility. Confirm that the digital night vision image aligns with
the real-life image at 30-50 meters using the 1X setting. Using a 3X magnifier (HOLOSUN HM3X) can be used to
achieve the best results.
2. Red Dot Sight Calibration
1） After fusion calibration, perform red dot sight zeroing.
2） The red dot sight has been mechanically zeroed at the factory to approximately 25 meters.
3） The Elevation adjustment is located on the right side of the housing and the windage adjustment is located
on the left side of the housing. Adjustments can be made using the included tools. (As shown in Figure 10)
4） 0.5 MOA Windage & Elevation adjustments, per click.
Each adjustment click has a value of approximately 0.5 MOA or 1/2 inch at 100 yards (1/4" at 50y; 1/8" at 25y).
When zeroing at 50 yards, if your point of impact is 2 inches low and 1 inch right, you will need to adjust Elevation
To Next Page
Loading...
Need help?
General