27
CONTROLS AND FEATURES
Power Tilt Switch
The power tilt switch is located on the
engine pan. It is a rocker switch with
UP and DN (down) positions for
changing the angle of the outboard
motor.
The power tilt switch will operate
without turning the ignition switch
ON.
This switch is used with the engine
stopped to raise the outboard motor
for mooring, trailering, or
maintenance.
Manual Relief Valve
The outboard motor can be tilted
manually after opening the manual
relief valve. This allows the outboard
motor to be tilted up or down when
no battery is connected.
Tilt Lock Lever
The tilt lock lever is used to support
the outboard motor in the fully-raised
position.
When the boat is to be moored for a
long time, tilt the outboard motor up
as far as it will go. Then move the tilt
lock lever to the LOCK position, and
gently lower the outboard motor until
the lever contacts the stern bracket.
MANUAL RELIEF VALVE
POWER
(To fix)
MANUAL
(To release)
31ZX26040.book Page 27 Friday, July 25, 2014 5:14 PM
To Next Page
Loading...
Need help?
General
