66
SERVICING YOUR OUTBOARD MOTOR
Engine Oil Change
An engine oil evacuation/filling
device may be used to remove/add
the engine oil.
Drain the used oil while the engine is
warm. Warm oil drains quickly and
completely.
1. Unlock and remove the engine
cover (p. 63).
2. Remove the screw from the drain
bolt cover, and remove the cover.
3. Set the drain bolt cover under the
oil drain guide.
4. Place a suitable container below the
oil drain guide to catch the used oil,
and then remove the oil filler cap,
drain bolt, and sealing washer.
5. Allow the used oil to drain
completely. Use a new sealing
washer, and then reinstall the
engine oil drain bolt and washer.
Tighten the drain bolt securely.
Improper disposal of engine oil can
be harmful to the environment.
If you change your own oil, please
dispose of the used oil properly.
Put it in a sealed container, and
take it to a recycling center. Do not
throw it in the trash, pour it on the
ground or down a drain.
6. Install the drain bolt cover and
secure it with the screw.
7. With the outboard motor in a
vertical position, fill to the upper
limit mark on the dipstick (p. 64)
with the recommended oil.
Engine oil refill capacity:
Without oil filter change:
8.0 US qt (7.6 L)
With oil filter change:
8.2 US qt (7.8 L)
8. Install the oil filler cap and tighten
it securely.
DRAIN BOLT
SCREW
DRAIN BOLT COVER
SEALING WASHER
OIL DRAIN
GUIDE
DRAIN BOLT COVER
DRAIN BOLT
31ZX26040.book Page 66 Friday, July 25, 2014 5:14 PM
To Next Page
Loading...
Need help?
General
