Parking Brake
Release the parking brake before driving. You will hear a beep if
you drive with it not fully released.
Seat Belt Reminder
The indicator blinks and beeps sound continuously if you or your
front passenger has not fastened your seat belts when you begin
driving. If the indicator remains on after seat belts are fastened,
see your dealer.
Low Fuel
Refuel as soon as possible. If the indicator blinks, there is a
problem with the fuel gauge. See your dealer.
• Comes on when the fuel reserve is running low (approximately
1.8 U.S. gal/7.0 Liter left).
• Blinks if there is a problem with the fuel gauge.
Low Tire Pressure / Tire Pressure Monitoring System (TPMS)
*1
• Comes on while driving:
Stop in a safe place, check tire pressures, and inflate tire(s) if
necessary.
System Message
Comes on along with a beep when a problem is detected. A system
message on the driver information interface (DII) appears at the
same time. Check the display for more information.
*1 - If equipped
INSTRUMENT PANEL
34 |
Immobilizer
Your key or remote transmitter cannot be recognized by the
vehicle.
• Blinks - You cannot start the engine. Turn the ignition switch to
LOCK (0)
*1
, pull the key out (for Canadian models only: apply and
hold the brake pedal before turning the ignition on). Then insert
the key and turn it to ON
*1
again.
• Repeatedly Blinks - The system may be malfunctioning. Have
your vehicle checked by a dealer.
• Do not attempt to alter this system or add other devices to it.
Electrical problems can occur.
Shift Indicators
*1
Upshift or downshift when the arrow comes on, for better
efficiency.
On/Off Indicators
These indicators remind you when an item is on or off.
VSA
®
off
VSA
®
engaged (blinks)
LKAS on
ACC
*1
with Low Speed
Follow
*1
on
Turn signals/hazards on
Fog lights
*1
on
High beams on
Exterior lights on
Auto High Beam System on
ECON mode
*1
on
Automatic brake hold on
Automatic brake activated
*1 - If equipped
INSTRUMENT PANEL
| 35
To Next Page
Loading...
Need help?
General
