Power Moonroof
*1
Operation
The moonroof can be opened and closed when the vehicle is on by using the
switch on the ceiling.
n Automatic Operation
To open: Firmly pull the switch back.
To close: Firmly push the switch
forward.
The moonroof automatically opens or
closes all the way. To stop the
moonroof midway, pull or push the
switch briefly.
n Manual Operation
To open: Pull the switch back lightly.
To close: Push the switch forward lightly.
Release the switch when the window reaches the desired position.
n
Moonroof Tilt
To tilt: Push the center of the switch.
To close: Push the switch forward firmly, then release.
Opening the moonroof in below freezing temperatures or when it is covered
with snow or ice can damage the moonroof panel or motor.
Opening or closing the moonroof on someone’s hands or fingers can cause
serious injury.
Make sure all hands and fingers are clear from the moonroof before
opening or closing it.
*1 - If equipped
VEHICLE CONTROLS
44 |
Interior and Exterior Lights
Operate interior and exterior lights when the vehicle is on or off.
n Brightness Control
Adjust instrument panel brightness
when the vehicle is on.
To brighten: Turn the knob to the right.
To dim: Turn the knob to the left.
A beep sounds when the brightness
reaches its minimum or maximum.
n Interior Lights
Change the interior light settings using the switches on the ceiling.
ON position: The interior lights come on regardless of whether the doors are
open or closed.
Door-activated position: Interior lights come on when any of the doors are
opened, the driver’s door is unlocked, or the vehicle is turned off.
Models without Smart Entry System: You remove the key from the ignition
switch.
Models with Smart Entry System: When the power mode is set to VEHICLE
OFF (LOCK).
VEHICLE CONTROLS
| 45
To Next Page
Loading...
Need help?
General
